Unique Element Design Coalescing Air Filter

Compressed air in industrial applications contains in 1Nmᶟ more than 100 million of polluting articles. Most of these particles are so small in dimension, less than 5 micron, that they cannot be intercepted by the standard intake filters installed in the compressors. Such particles, mixed with water and oil vapour generated during compression, cause the early wear and tear of the appliances and consequently they are the cause of expensive interruptions of the production and remarkable increase maintain.

Selection right Compressor Air Dryer filters will allow the best choice of the suitable equipment according to the quantity of air to be treated and the necessary filtration degree in order to increase and improve the performances of the whole system. 

FEATURE & ADVANTAGE

①Casing 100% Leakage-tested, with 15 years spanlife. Low overall cost for owner.

②No-touch Element design, easy to maintenance and repairement.

③Follow ISO8573.1-2010 Standard in Class 1 filtration performance. Protect your precise equipment and optimization your production efficiency.

④Low pressure drop, saving energy and money.

For more questions about how to choose a particle air filter for your compressed air system, how to maintain the air compressor filter in daily, how long the coalescing air filter should be maintained, and how the compressor air filter works, please contact us by email or phone.

HOW TO INSTALL Compressed Air Filter?

①Clean the compressed air pipes and valves connected to the air inlet and outlet of the filter before installation.

② Adopt the combination of main pipe filtration and terminal filtration to ensure the gas quality at the point of use.

③ When installing, the air inlet and outlet of the filter should be kept level, and the sewage outlet should be at the bottom. A certain space must be reserved in the vertical direction to facilitate the maintenance of the filter and the replacement of the filter element.

④The filter of the screw air compressor should be installed in a ventilated and cool place, as close as possible to the air point, to reduce the influence of the pipeline on the quality of the filtered compressed air.

⑤ Install and use within the specified working pressure and working temperature range, and install all levels of filters in the correct order according to the air inlet and outlet instructions or the direction indicated by the arrow, from coarse to fine installation. Avoid bypass as much as possible during installation. Because the oil in the air is bypassed to the downstream of the filter and then sticks to the inner wall of the pipeline, it is difficult to find effective means to remove it. 
⑥The filter element should be replaced regularly. Carefully record the replacement time. It is recommended that the working time zone should not exceed 6000 hours.

⑦The discharge time of the auto drain is suitable for draining the liquid water, and the discharge interval is subject to the water content in the pipeline;

8. Different grades of compressed air filters can be equipped with zero pressure loss floating ball drain valves or manual valves according to customer requirements.

TECHNICAL SPECIFICATION

The flow rate below is the treatment capacity of compressed air under rated working pressure 7 barg (100psi g). For the application in other working pressure, please refer to the correction factors.

REPLACEMENT & SPARE PARTS